arch supports
home
information
products
order
email
about us
contact us
Shipping Information
privacy
disclaimer
return policy

Call Us Toll Free 888 671 8027 M-F 10 to 6 Pacific Time

Spenco
Gel Insole
Active Energy From Start To Finsh

Spenco Gel insoles are made from a tri density Thermo Polyurethane Rubber (TPR) Gel and are covered with a low friction synthetic top cover. These insoles provide superior gel cushioning from heel to toe while reducing friction which can cause blisters, corns and calluses on the bottom of the feet and toes.
Spenco Gel Insoles have the typical gooey TPR gel insole feeling that one would expect from a gel insole but the Spenco Gel Insole adds three additional features that increase the gel insole’s shock absorption, support and comfort level. These Spenco Gel Insoles incorporate a hexagon cushion structure that increases the cushioning and shock absorption at the critical weight bearing points of the feet, the heel and the ball of the foot. Spenco Gel Insoles also have an additional cushioning feature in the heel. The orange hexagon cushion pad is actually made from a lower density (softer) TPR gel than the rest of the insole so it provides even more cushioning for high impact heel strikes. Finally, the gray arch piece is made from a higher density (harder) TPR gel that provides mild anatomical contouring for comfort and support to the medial and lateral arch.

More About the Hexagon Cushioning Design of the Spenco Gel Insole
A Typical TPR solid Gel insole has only a limited amount of compression due to the density of the gel. This means that upon a hard impact its shock absorbing capacity is equally limited. By comparison, foam based cushioning materials (such as those used to make the Spenco Polysorb Crosstrainer) offer considerably more shock absorption because the bubble cells in the foam rubber compress and recoil to a greater degree than a solid layer of TPR gel can.
The hexagon design in the new Spenco Gel Insole changes this cushioning aspect and significantly improves the shock absorption capabilities of the new Spenco Gel insoles. The hexagon design creates structurally supported air pockets in the gel that allows it to compress and recoil in a way that is similar to the bubble cells in foam based cushion insoles. This design allows it to absorb more shock and provide more cushioning than solid TPR gel insoles.

SPENCO
Gel Insoles - $13.25 Per Pair

Shipping Options
Order Here
Shipping Prices
If you purchase 1 pair of SPENCO Gel Insoles then you can choose between First Class Mail (5 to 8 days) or Priority Mail (3 to 5 days). For 2 or more pair, please select Priority Mail as they are too heavy to send via First Class Mail. For detailed ordering instructions click the button below.
 
Quantity:
Size:
California Sales Tax applies on orders shipped to CA destinations only.
INTERNATIONAL ORDERS
Please select the "International Shipping" setting on the Billing & Shipping check out page for shipping outside the US.
First Class
Priority
1 Pair
$4.24
$5.90 to $7.30
Varies Based on Destination
2 - 3 Pair
Not Available
$6.10 to $11.70
Varies Based on Destination
4 Pair
Not Available
$6.85 to $15.65
Varies Based on Destination
5 - 6 Pair
Not Available
$7.70 - $18.80
Varies Based on Destination
7 Pair
& Up
Not Available
$9.10 - $21.70& Up
Varies Based on Destination
Need Assistance?
Call Toll Free 888-671-8027
Outside US Call 415-504-8529